Instructions For Use
1.Connect the vehicle's wireless charging device to the appropriate data cable when using it.
2, Connect the USB port of the data cable to the charging interface on the car(e.g. cigarette lighter switching charger or using QC3.0 car charger. If you use the car charging head without fast charging, there may be other problems such as slow charging)
3. The device clip clips the air outlet and can also be placed elsewhere.
4. After the equipment is powered on with 5-9v DC, the logo atmosphere light will be on and automatically checked. Checking and closing the tight reset once, and the green light flashes. After starting the reset, the green light is on. When the front of the object is 5cm-20cm close to the equipment, it automatically senses to open its arms. After the mobile phone is put in, the device automatically clamps the mobile phone. At this point, the wireless charger will charge the opponent. The machine will automatically charge. After wireless charging is detected, the green light will automatically turn off. When taking out the mobile phone, you need to touch the convex on the top of the rear case or touch the sensing point before. When the hand touches the position of the sensing point the device will automatically open its arms and then you can take out the mobile phone.
5. The equipment has overvoltage protection, over temperature protection and magnetic field protection, short circuit protection. If the equipment is abnormal, it will automatically stop working.
6. The fuselage equipment has a built-in battery, and the bracket can be opened without connecting the power data cable. The closing and tightening works normally (wireless charging does not work), by touching the front or back sensing point. The wake-up logo atmosphere light will on for 5 seconds and automatically goes out.
7. Instructions for adjusting the gear up and down of the bottom bracket:
a). The bottom bracket can be adjusted up and down according to different sizes of mobile phones;
The alignment between the charging coil and the receiving end of the mobile phone is more accurate higher charging efficiency.
b). Adjust the lower operation, hold the bottom support bracket and gently pull it down to use the mobile phone proper size and gear
c). Adjust the upper operation, hold the bottom support bracket and gently push it upward to use the mobile phone proper size and gear (Note: the coil at the wireless charging receiving end of the mobile phone is basically located at The central end area on the back of the mobile phone.)
